H-rail for rainproof installation of framed modules

This H-rail developed by us turns your modules into a rainproof roof skin. The modules are slid into the H-rails and secured with the supplied end plates. A sealing tape made of weather-resistant cellular rubber is inserted at the narrow joint for sealing. This allows you to create a rainproof PV roof quickly and cost-effectively. The roof pitch must be at least 6° or 10%. ( 1 metre - 10cm height difference? )

We stock these H-rails for modules with 30 mm, 35 mm and 40 mm frames.

Only for the 30 mm modules do we stock rails in the lengths 3.534 m, 5.306 m and 7.078 m.

The regular specified rail lengths of 3.50 m, 5.20 m and 7.0 m apply to the  35 mm and 40 mm modules.

Scope of delivery:

H-rail, cellular rubber, 2 x end plate, 2 x M10x30 screw

Please note that only modules with Approval for overhead installation, such as our GridParity B108 modules, provide safety for this application.

Material: Aluminium, black anodised, similar to RAL 9004

Note: The colour shade of the rails may vary slightly . Due to the production process, isolated grey areas may occur on the surface.
Scratches may occur on the anodised surface during storage and transport. This cannot be prevented, as the anodised layer is relatively thin and minor imperfections are normal with this type of surface treatment.
 

Please provide us with the exact dimensions of your modules and the planned installation via the information field during the ordering process so that we can adapt the system to your requirements.

If the selectable rail lengths do not fit the module sizes you wish to install, the respective rails can be extended by up to 60 cm for an additional charge of €12.90 per rail. A further extension beyond this is possible for an additional charge. For this purpose, please also provide us with the information on the desired extension in the comment/information field before completing the order.