Mounting system for framed modules 30 mm, length 3.534 m

This H-rail developed by us turns your modules into a watertight roof covering. The modules are slid into the H-rails and secured with the supplied end plates. A sealing tape made of weather-resistant cellular rubber is inserted at the narrow joint for sealing. This allows you to create a watertight PV roof quickly and cost-effectively. The roof pitch must be at least 6° or 10%. ( 1 metre - 10cm height difference? )

We stock these H-rails for modules with 30 mm, 35 mm and 40 mm frames.

Exclusively for 30 mm modules, we stock rails in lengths of 3.534 m, 5.306 m and 7.078 m.

The regular specified rail lengths of 3.50 m, 5.20 m and 7.0 m apply to 35 mm and 40 mm modules.

Scope of delivery:

H-rail, cellular rubber, end plate, M10x30 screw

Please note that only modules with Approval for overhead installation, such as our GridParity B108 modules, provide safety for this application.

Material: Aluminium, black anodised, similar to RAL 9004

Note: The shade of the rails may vary slightly. Due to the production process, isolated grey areas may occur on the surface.
Storage and transport may cause scratches on the anodised surface. This cannot be prevented, as the anodised layer is relatively thin and minor imperfections are normal with this type of surface treatment.
 

Please provide us with the exact dimensions of your modules and the planned installation via the information field during the ordering process so that we can adapt the system to your requirements.

If the selectable rail lengths do not fit the dimensions of the modules you intend to install, the respective rails can be extended by up to 60 cm for an additional charge of € 12.90 per rail. Any further extension is possible for an additional charge. For this purpose, please also provide us with the information regarding the desired extension in the comment/note field before completing the order.