Mounting system for framed modules 30 mm, length 3.534 m

This H-rail developed by us turns your modules into a rainproof roof covering. The modules are slid into the H-rails and secured with the supplied end plates. At the narrow joint, a sealing tape made of weather-resistant cellular rubber is inserted for sealing. This allows you to create a rainproof PV roof quickly and cost-effectively. The roof pitch must be at least 6° or 10%. ( 1 metre - 10cm height difference? )

We stock these H-rails for modules with 30 mm, 35 mm and 40 mm frames.

Exclusively for the 30 mm modules, we stock rails in the lengths 3.534 m, 5.306 m and 7.078 m.

For the  35 mm and 40 mm modules, the regularly specified rail lengths of 3.50 m, 5.20 m and 7.0 m apply.

Scope of delivery:

H-rail, cellular rubber, end plate, M10x30 screw

Please note that only modules with Approval for overhead installation, such as our GridParity B108 modules, provide safety for this application.

Material: Aluminium, black anodised, similar to RAL 9004

Note: The shade of the rails may vary slightly . Due to the production process, grey areas may occasionally occur on the surface.
Storage and transport may cause scratches on the anodised surface. This cannot be prevented, as the anodised layer is relatively thin and minor imperfections are normal with this type of surface treatment.
 

Please provide us with the exact dimensions of your modules and the planned installation in the information field during the ordering process so that we can adapt the system to your needs.

If the selectable rail lengths do not fit the module sizes you intend to install, the respective rails can be extended by up to 60 cm for an additional charge of 12.90 € per rail. Any extension beyond this is possible for a further additional charge. For this purpose, please also provide us with the information on the desired extension in the comment/note field before completing the order.